Read Sharp MX-6201N / MX-7001N (serv.man36) Service Manual online
MX-7001N DEVELOPING SECTION L – 4
a. Developer (C/M/Y)
1)
Remove the development unit (CL). (Refer to the "(1) Devel-
opment unit (CL)".)
opment unit (CL)".)
2)
Remove the screws (A).
3)
Tilt the developing unit (CL) (B) so that developer is moved to
the MG roller side.
the MG roller side.
4)
Lift the cover (D) from the magnet roller side with the pawl at
the section (C) as the center of rotation, and slide it to the
arrow mark (E) side to remove.
(In order to prevent developer from attaching to the magnet.)
the section (C) as the center of rotation, and slide it to the
arrow mark (E) side to remove.
(In order to prevent developer from attaching to the magnet.)
5)
Take out the old developer (F), and infuse the developer (G).
* When replacing developer, use an extreme care not to drop
developer on the drive section (marked with {).
* [Important information]
(Note for cleaning the development unit)
If the development unit is cleaned with a cleaner or an air
blower with much developer in the development unit, static
electricity may be accumulated in the unit. In order to pre-
vent against this, note the following items.
If the development unit is cleaned with a cleaner or an air
blower with much developer in the development unit, static
electricity may be accumulated in the unit. In order to pre-
vent against this, note the following items.
Unit
Parts
Mainte
nance
1
Development unit
(CL)
(CL)
a
Developer (C/M/Y)
▲
1-a
A
A
B
D
C
E
G
1-a
F
Click on the first or last page to see other MX-6201N / MX-7001N (serv.man36) service manuals if exist.