Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man63) Service Manual online
MX-7000N DEVELOPING SECTION L – 10
d. Hopper remaining sensor K
1)
Remove the development unit (BK). (Refer to the “(1) Develop-
ment unit (BK)”.)
ment unit (BK)”.)
2)
Remove the screws (A), and remove the sheet (B). Remove
the screws (C), and remove the hopper remaining sensor K
(D). Disconnect the connector (E).
* When installing, arrange the snap band (F) so that there is in
the screws (C), and remove the hopper remaining sensor K
(D). Disconnect the connector (E).
* When installing, arrange the snap band (F) so that there is in
the upper side of the projection (G), then engage the har-
ness (H) to cut-out portion of the projection (G).
ness (H) to cut-out portion of the projection (G).
e. Intermediate hopper motor
1)
Remove the development unit (BK). (Refer to the "(1) Devel-
opment unit (BK)".)
opment unit (BK)".)
2)
Remove the screws (A), and remove the toner hopper unit (B).
* When installing, engage the toner hopper unit to pawls (C)
* When installing, engage the toner hopper unit to pawls (C)
of the MG roller unit.
3)
Disconnect the connector (D) on front side, and the connector
(E) on rear side.
(E) on rear side.
4)
Remove the screws (F), and remove the intermediate hopper
motor unit (G).
motor unit (G).
Unit
Parts
1
Development unit
(BK)
(BK)
d
Hopper remaining sensor K
Unit
Parts
1
Development unit
(BK)
(BK)
e
Intermediate hopper motor
1-d
A
A
B
E
1-d
C
D
F
H
G
H
1-e
B
A
A
C
D
E
F
G
F
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man63) service manuals if exist.