Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man24) Peripheral online
MX-CFX1 OPERATIONAL DESCRIPTION 5 – 5
Setting procedure:
1) Place a sheet in the tray.
2) Press the STAPLE MODE switch on the operator panel.
3) Each time you press the switch, the STAPLE MODE LEDs
1) Place a sheet in the tray.
2) Press the STAPLE MODE switch on the operator panel.
3) Each time you press the switch, the STAPLE MODE LEDs
light up by turns in the following order: 1, 2, 3, 4 All LEDs OFF
1 ... (When the saddle mode is cannot be used, the order is: 1
2, 3, All LEDs OFF 1 ...)
1 ... (When the saddle mode is cannot be used, the order is: 1
2, 3, All LEDs OFF 1 ...)
4) When the desired LED lights up, press the START switch to
start operation.
(Refer to the correspondence between the stapling modes and
LEDs shown later.)
LEDs shown later.)
Canceling procedure:
5)
5)
Press the STAPLE MODE switch on the operator panel.
6)
All the STAPLE MODE LEDs go out to indicate that setting has
been canceled.
been canceled.
NOTE: If you cannot make or cancel setting by following the
respective procedures above, refer to "5. LED indication on
operation panel" shown later. When no LEDs are lit, check
the setting made by the main unit and the inserter status.
operation panel" shown later. When no LEDs are lit, check
the setting made by the main unit and the inserter status.
NOTE: The punching mode and saddle mode cannot be used at
the same time.
The correspondence between the punching/stapling mode settings and LEDs is shown below.
*
●: means "Lit."
Punch
LED
Staple mode LEDs
Stapling mode
LED1
LED2
LED3
LED4
❍
●
❍
❍
❍
1-point stapling at back
❍
❍
●
❍
❍
2-point stapling
❍
❍
❍
●
❍
1-point stapling at front
❍
❍
❍
❍
●
Saddle stapling (saddle stitching)
●
❍
❍
❍
❍
Punching
●
●
❍
❍
❍
Punching + 1-point stapling at back
●
❍
●
❍
❍
Punching + 2-point stapling
●
❍
❍
●
❍
Punching + 1-point stapling at front
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man24) service manuals if exist.