Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man18) Peripheral online
MX-FNX4 DISASSEMBLY AND ASSEMBLY 6 – 10
c. Removal of front inside upper cover
1) Remove the four screws [1], and remove the front inside upper
1) Remove the four screws [1], and remove the front inside upper
cover [2].
* For MX-FNX3, refer to 1-A-(3)-d.
d. Removal of stapler
1) Pull out the stapler, remove the screw [1], and remove the PCB
1) Pull out the stapler, remove the screw [1], and remove the PCB
cover [2].
2) Release the pawl [3], and remove the PCB [4].
3) Disconnect the connectors [5] at three positions.
4) Remove the screw [6], and remove the stapler with the stapler
3) Disconnect the connectors [5] at three positions.
4) Remove the screw [6], and remove the stapler with the stapler
base [7].
CAUTION: When removing, be careful not to damage the plug [8].
5)
Turn back the stapler, and disconnect the connectors [9] at two
positions, and remove the two screws [10]. Remove the stapler
from the stapler base.
positions, and remove the two screws [10]. Remove the stapler
from the stapler base.
(2) Swing unit
a. Removal of front cover
1)
1)
Open the front cover [1], and remove the clip [2].
2)
Lift the front cover [1], and remove it.
* For MX-FNX3, refer to 1-A-(1)-a.
b. Removal of rear cover
1)
1)
Shift the tray cable cover [1] to the tray side, and remove it.
2)
Remove the six screws [2], and lift and remove the rear cover
[3].
[3].
* For MX-FNX3, refer to 1-A-(2)-a.
[1]
[2]
[1]
[2]
[1]
[8]
[5]
[3]
[4]
[7]
[6]
[10]
[9]
[1]
[2]
[2]
[1]
[3]
[2]
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man18) service manuals if exist.