MX-5500N, MX-6200N, MX-7000N (serv.man18). MX-FNX3 4 MX-RBX2 MXPNX2A-D SERVICE MANUAL-Disassembly Assembly-1 - Sharp Copying Equipment Peripheral (repair manual). Page 25

Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man18) Peripheral online

MX-FNX4  DISASSEMBLY AND ASSEMBLY  6 – 25
7) Disconnect the connector [16], and remove the harness from
the clamp and the edge saddle [17].
8) Remove the two screws [18], and pull out the stapling tray [19]
in the delivery direction.
CAUTION: When removing parts in the stapling tray, do not apply a
force to the alignment plates (front/back) and the three
positions on the rear edge regulation plate. 
(2) No. 1 tray
a. Removal of front cover
1) Open the front cover [1], and remove the clip [2].
2) Lift the front cover [1], and remove it.
* For MX-FNX3, refer to 1-A-(1)-a.
b. Removal of rear cover
1)
Slide the tray cable cover [1] to the tray side, and remove it. 
2)
Remove the six screws [2], and lift and remove the rear cover
[3].
* For MX-FNX3, refer to 1-A-(2)-a.
c. Removal of saddle inlet front inside cover
1)
Remove the three screws [1], and remove the saddle inlet front
inside cover [2].
d. Removal of front inside upper cover
1)
Remove the four screws [1], and remove the front inside upper
cover [2].
* For MX-FNX3, refer to 1-A-(3)-d.
[18]
[17]
[19]
[18]
[16]
[1]
[2]
[2]
[1]
[3]
[2]
[1]
[2]
[1]
[1]
[2]
[1]
Page of 39
Display

Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man18) service manuals if exist.