Read Sharp MX-5050N / MX-5050V / MX-5070N / MX-5070V / MX-6050N / MX-6050V / MX-6070N / MX-6070V (serv.man7) Service Manual online
MX-6070N MX-FN31 (SADDLE STITCH FINISHER) 15 – 3
2. Installation
Check to confirm that the firmware version is later than below.
If the version is older upgrade the firmware.
Firmware version: 01.01.Z1.00
Before installation, be sure to turn both the operation and main power
switches off and disconnect the power plug from the power outlet.
Make double sure that the data lamp on the operation panel does not
light up or blink when performing installation.
switches off and disconnect the power plug from the power outlet.
Make double sure that the data lamp on the operation panel does not
light up or blink when performing installation.
A. Preparation on the main unit
1)
Install the connection guide plate (Packed item No1.) with the
screws (x4) (Packed item No.5).
screws (x4) (Packed item No.5).
2)
Insert the rib of the interface pass guide (Packed item No.2) into
the hole of the main unit, and install it with the screw (Packed item
No.6).
the hole of the main unit, and install it with the screw (Packed item
No.6).
B. Installation of the earth plate
1)
Install the earth plate (Packed item No.3) with the screws (Packed
item No.6).
item No.6).
C. Installation of the stapler unit staple case
1)
Open the front cover. Install the stapler unit staple case (Packed
item No.4) into the stapler unit.
item No.4) into the stapler unit.
NOTE: The staple unit cannot be fixed if the power is OFF. When
installing the stapler unit staple case, insert it while holding it
so that the stapler unit cannot go deep inside.
so that the stapler unit cannot go deep inside.
A
B
C
Click on the first or last page to see other MX-5050N / MX-5050V / MX-5070N / MX-5070V / MX-6050N / MX-6050V / MX-6070N / MX-6070V (serv.man7) service manuals if exist.