Read Sharp MX-3500N / MX-3501N / MX-4500N / MX-4501N (serv.man12) Service Manual online
MX3501N DISASSEMBLY AND ASSEMBLY 5 – 11
9)
Remove the DSPF No.1 resist roller brake clutch and the
DSPF No.1 resist roller clutch. (Refer "3. Upper transport sec-
tion - A. DSPF No.1 resist roller brake clutch - B. DSPF No.1
resist roller clutch.")
DSPF No.1 resist roller clutch. (Refer "3. Upper transport sec-
tion - A. DSPF No.1 resist roller brake clutch - B. DSPF No.1
resist roller clutch.")
10) Remove the drive unit. (Refer to "7. Drive section - A. Drive
unit.")
11) Disconnect the connector. Remove the screw, and remove the
control PWB unit.
12) Loosen the screw, and loosen the belt tension. Tighten the
screw. Remove the belt. Remove the E-ring and the pulley.
13) Remove the resin E-ring. Slide the bearing. Remove the trans-
port roller 2 (drive). Remove the bearing, the E-ring, and the
spring pin from the transport roller 2 (drive).
spring pin from the transport roller 2 (drive).
J. Transport roller 3 (drive)
1)
Remove the front cabinet. (Refer to "1. Exterior section - A.
DSPF unit - (1) Front cabinet.")
DSPF unit - (1) Front cabinet.")
2)
Remove the rear cabinet. (Refer to "1. Exterior section - A.
DSPF unit - (2) Rear cabinet.")
DSPF unit - (2) Rear cabinet.")
3)
Remove the paper feed unit. (Refer to "2. Paper feed section -
B. Paper feed unit.")
B. Paper feed unit.")
4)
Remove the DSPF No.1 resist roller brake clutch and the
DSPF No.1 resist roller clutch. (Refer to "3. Upper transport
section - A. DSPF No.1 resist roller brake clutch, B. DSPF
No.1 resist roller clutch.")
DSPF No.1 resist roller clutch. (Refer to "3. Upper transport
section - A. DSPF No.1 resist roller brake clutch, B. DSPF
No.1 resist roller clutch.")
5)
Remove the drive unit. (Refer to "7. Drive section - A. Drive
unit.")
unit.")
6)
Remove the resin E-ring, and remove the No.1 resist roller
(idle).
(idle).
7)
Remove the screw. Lift the paper feed rotation tray, and
remove the paper feed PG lower.
remove the paper feed PG lower.
8)
Disconnect the connector. Remove the screw, and remove the
control PWB unit.
control PWB unit.
1
1
2
2
3
1
2
3
1
2
3
3
1
2
1
2
1
1
2
2
3
Click on the first or last page to see other MX-3500N / MX-3501N / MX-4500N / MX-4501N (serv.man12) service manuals if exist.