Read Sharp MX-2630 (serv.man6) Handy Guide online
INITIAL SETUP
SHARP
Page 10
/75
MX-2630N Handy Guide NOV’17
Sharp Office Solutions Group
PRINT IMAGE POSITION & BK MAGNIFICATION:
Check Print Image Off Centre & Lead Edge position - Use Sim 50-10:-
• Inside dimension of the printed halftone must be 240±0.5mm.
• Lead edge void area 3.0 ± 1.0mm.
• Rear edge void area 2.0mm - 5.0mm.
• Front & Rear Void areas 2.0 ± 2.0mm.
• Lead edge void area 3.0 ± 1.0mm.
• Rear edge void area 2.0mm - 5.0mm.
• Front & Rear Void areas 2.0 ± 2.0mm.
If NG, perform the following adjustments as required:-
Manual Adjustment:
Sim 50-10
BK MAG / Image Off Centre Adjustment (All Trays).
Sim 50-05
Printer Lead Edge & Void Adjust.
Automatic Adjustment:
Sim 50-28
BK MAG ADJ (Main Scan Mag).
SETUP/PRINT ADJ (Lead, Offset or All).
IMAGE SKEW & COLOUR REGISTRATION
Sim 50-22
Colour Registration/Skew & OPC Drum Phase Adjustment:
Check/Adjust SKEW (CMY) so value is Close to 0 as possible (Result=OK).
HALFTONE COLOR CALIBRATION
Sim 46-74
Engine & Printer Colour Calibration:
Select FACTORY Mode.
IMAGE QUALITY CHECK [COPY & PRINT]
Check Image Quality – Density, Magnification, Lead Edge & Void.
If NG, perform the following adjustments as required:
F/R Evenness Adjustment:
Sim 61-13
F/R Evenness Correction Data Clear
Sim 61-11
F/R Evenness Correction Adjustment
Note: Sim 46-74 must be executed after F/R adjustment is performed.
Copy Density Manual Adjustment:
Sim 46-01
Copy Density Adjust. (Colour).
Sim 46-02
Copy Density Adjust. (B/W).
Sim 46-09
SPF Copy Density Adjust.
Print Image Manual Adjustment (Lead Edge, Void, Off Centre etc.):
Sim 48-01
Magnification Adjustment (OC & SPF).
Sim 50-01
Lead/Rear Edge, Loss & Void Adjust.
Sim 50-12
OC & SPF Off Centre Adjust.
Check Print Image Quality:
Sim 64-05
PCL Density Test Page
Sim 64-06
PS Density Test Page
Click on the first or last page to see other MX-2630 (serv.man6) service manuals if exist.