MX-2314N (serv.man95). MX-2314 ROM UPGRADE (4) Firmware u2.00.G2 (Bulletin Only) - Sharp Copying Equipment Technical Bulletin (repair manual). Page 2

 
 
 

2/2 

[Description] 

No. Item 

Details 

1 Printer 

PS job could not occasionally be printed under Mac/Linux environment.    This problem is 
corrected. 

2 Printer 

Print failure occurred that for example, sometime the logo mark was not printed properly 
if particular data were printed vial PCL5 driver. This problem has been corrected. 

3 

Network 
communication

 

If the first character of PC name was the number (0-9), in some cases, it was not 
possible to connect to PC when OSA was activated. 

4 

Network 
communication

 

In very rare cases, print job stopped during execution of print. This problem is corrected.

5 

Network 
communication

 

Sometimes the error message "Error 3333 - Set Kerberos Server" appeared even after 
setting the data on Kerberos. This problem has been corrected. 

6 

Network 
communication 

Modified to perform a security check input limit item type the following security key every.
  When type = WPA security 
    - Can be registered as a string: 5 digits / 13 digits   
    - Can be registered only Hex: 10 digits / 26 digits   
    - No registration other than the above 
 
  When type = WPA security 
    - Can be registered as a string: 8-digit to 63-digit 
    - Can be registered only Hex: 64 digits 
    - No other registration 

7 Image 

Send 

While reconnecting to the server with support for passive mode after failing to the 
connection in active mode, the communication was not allowed for a while depends on 
the server. In that case, the data transmission to FTP site was not allowed until the 
recovery. A Soft SW has been added as a countermeasure so that the connection in 
passive mode is allowed in the first place. 
 
  FAX soft SW (in Sim66-1) 
  SW No. 96    Bit No. 4 
 
0: Connection in active mode (default) 
1: Connection in passive mode 

8 Image 

Send 

If original data were scanned after defining the original as an inch-based size, the job 
ended up with a page size error depend on application. This problem has been 
corrected. 

9 Image 

Send 

Sometime data output failed after experiencing a Fax communication error "16-0030". 
This problem has been corrected. 

10 

Main unit control 

Sometimes the machine did not show default screen even after reaching to auto clear 
time. This problem has been corrected. 

11 

Main unit control 

In some cases, MFP was unable to recover from deep sleep.    This problem has been 
corrected. 

12 

Main unit control 

If a paper tray got empty during subsequent job while performing multiple jobs in series, it 
switched to another tray automatically even when Auto Switching of Tray was disabled. 
This problem has been corrected. 

13 

Main unit control 

A new Simulation mode has been developed to conform to new standard of "Blue Angel" 
(eco-label for Germany). The check box for Auto power shut off mode is not displayed 
when this mode is enabled that machine enters Auto power shut off mode at any time. 
 
Sim26-50 POWER SHUT-OFF SET 
 
While checkbox is not displayed: The machine is under factory default condition for 
EUROPE/UK. 
While displayed: The machine is under factory default condition for those other than 
EUROPE/UK.