Read Sharp MX-2300N / MX-2700N / MX-2300G / MX-2700G / MX-2300FG / MX-2700FG (serv.man28) User Guide / Operation Manual online
4
INSTALLATION REQUIREMENTS
Improper installation may damage this product. Please note the following during initial installation and whenever the
machine is moved.
machine is moved.
1. The machine should be installed near an accessible
power outlet for easy connection.
2. Be sure to connect the power cord only to a power
outlet that meets the specified voltage and current
requirements. Also make certain the outlet is properly
grounded.
requirements. Also make certain the outlet is properly
grounded.
• For the power supply requirements, see the name
plate at the bottom of the back of the left side of the
machine.
machine.
Connect the machine to a power outlet which is not
used for other electric appliances. If a lighting fixture is
connected to the same outlet, the light may flicker.
used for other electric appliances. If a lighting fixture is
connected to the same outlet, the light may flicker.
3. Do not install the machine in areas that are:
• damp, humid, or very dusty
• exposed to direct sunlight
• poorly ventilated
• subject to extreme temperature or humidity
• exposed to direct sunlight
• poorly ventilated
• subject to extreme temperature or humidity
changes, e.g., near an air conditioner or heater.
4. Be sure to allow the required space around the
machine for servicing and proper ventilation.
5. When moving the machine, four persons must firmly
grasp the transport handles on both sides of the
machine.
machine.
6. The machine includes a built-in hard drive. Do not
subject the machine to shock or vibration. In
particular, never move the machine while the power is
on.
particular, never move the machine while the power is
on.
45 cm
(17-23/32")
(17-23/32")
30 cm
(11-13/16")
(11-13/16")
30 cm
(11-13/16")
(11-13/16")
A small amount of ozone is produced within the printer during operation. The emission level is insufficient to cause any health
hazard.
hazard.
NOTE:
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m
3
) calculated as an 8 hr. time-weighted average
concentration.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a ventilated
area.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a ventilated
area.
mx2700_gb_saf.fm 4 ページ ２００５年１１月１日 火曜日 午後４時５１分
Click on the first or last page to see other MX-2300N / MX-2700N / MX-2300G / MX-2700G / MX-2300FG / MX-2700FG (serv.man28) service manuals if exist.