MX-1800N (serv.man6). Installation Manual - Sharp Copying Equipment Service Manual (repair manual). Page 12

MX-2300G/N, MX-2700G/N  1 – 9

5) After entering the data, close the front cabinet.

6) Select K, C, M, Y and then press the [EXECUTE] button. The

system then performs the simulation, samples the toner den-
sity control sensor value, and sets (stores in memory) the
average sensor detection level as the control level for the ref-
erence toner density.

Note: Be sure to select all of the four colors: K, C, M, Y.

7) Exit from Simulation mode by pressing the [CA] key on the

main unit.

* The life of each toner cartridge is as follows:

Black toner cartridge: equivalent to approximately 18K (A4/LT
5%)
Color toner cartridge: equivalent to approximately 15.0K (A4/LT
5%)

1) Shake the toner cartridge (package part No. 1) horizontally

several times.

2)

Remove the heat seal. 

3)

Open the front cover, and insert each toner cartridge.

* Be sure to install the color cartridges to their proper posi-

tions. Avoid installation to a different color position. 

* Do not forcibly insert the toner cartridge.

Keep holding the cartridge and completely insert it.

* When the machine is transported with the developing unit

removed, be sure to remove the toner cartridge. (If not, tone
may be clogged.)
[Color toner cartridge positions]

4)

Insert the cartridge securely until it locks.

0

SIMULATION NO.25-02

TEST

AUTOMATIC DEVELOPER ADJUSTMENT

EXECUTE

AT DEVE ADJ_L_K

128

:

AT DEVE VO_L_K

128

:

AT DEVE ADJ_L_C

128

:

AT DEVE VO_L_C

128

:

AT DEVE ADJ_L_M

128

:

AT DEVE VO_L_M

128

:

AT DEVE ADJ_L_Y

128

:

128

:

1/2

CLOSE

AT DEVE VO_L_Y

K

C

M

Y