Read Sharp DX-C200 Service Manual online
DXC200/200P NOTE FOR SERVICING - i
The quantity of ozone produced is designed to a low level so as not to affect human bodies.
However, continuous use of such a machine may produce an ozone smell. Install the
machine in a well ventilated place.
•
However, continuous use of such a machine may produce an ozone smell. Install the
machine in a well ventilated place.
•
Place of direct sunlight.
Plastic parts and ink may be deformed, discolored, or may undergo qualitative change.
It may cause a breakdown or output quality problems.
•
It may cause a breakdown or output quality problems.
•
Place which is full of organic gases such as ammonium
The organic photo-conductor (OPC) drum used in the machinemay undergo qualitative
change due to organic gases such as ammonium.
Installation of this machine near a diazo-type copier and blue print machine may result in
poor quality output.
•
change due to organic gases such as ammonium.
Installation of this machine near a diazo-type copier and blue print machine may result in
poor quality output.
•
Place of much dust
When dust or contaminants enters the machine, it may cause a breakdown or poor quality
output.
•
output.
•
Place near a wall
The machine will require ventilation.
If ventilation is not proper, poor output or machine failure may result.
•
If ventilation is not proper, poor output or machine failure may result.
•
Unstable or irregular surface
If the machine is dropped or tips over, it may cause injury or machine malfunction.
Use an optional desk or an exclusive-use desk.
When using the optional desk, be sure to fix the adjuster and lock the casters.
4. Note for handling PWB and electronic parts
When handling the PWB and the electronic parts, be sure to observe the following
precautions in order to prevent against damage by static electricity.
• When in transit or storing, put the parts in an anti-static bag or an anti-static case and do
not touch them with bare hands.
• When and after removing the parts from an anti-static bag (case), use an earth band as
shown below:
• Put an earth band to your arm, and connect it to the machine.
• When repairing or replacing an electronic part, perform the procedure on an anti-static mat.
Use an optional desk or an exclusive-use desk.
When using the optional desk, be sure to fix the adjuster and lock the casters.
4. Note for handling PWB and electronic parts
When handling the PWB and the electronic parts, be sure to observe the following
precautions in order to prevent against damage by static electricity.
• When in transit or storing, put the parts in an anti-static bag or an anti-static case and do
not touch them with bare hands.
• When and after removing the parts from an anti-static bag (case), use an earth band as
shown below:
• Put an earth band to your arm, and connect it to the machine.
• When repairing or replacing an electronic part, perform the procedure on an anti-static mat.
Click on the first or last page to see other DX-C200 service manuals if exist.