DX-C200. Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 13

Read Sharp DX-C200 Service Manual online

photoconductor in accordance with local regulations. (These are non-toxic supplies.) 
3.  Dispose of replaced parts in accordance with local regulations. 
 
  To prevent a fire or explosion, keep the machine away from flammable liquids, 
gases, and aerosols. A fire or an explosion might occur. 
 
  The Controller board on the DX-C200 contains a lithium battery. The danger of 
explosion exists if a battery of this type is incorrectly replaced. Replace only with 
the same or an equivalent type recommended by the manufacturer. Discard 
batteries in accordance with the manufacturer's instructions and local regulations. 
Laser Safety 
The Center for Devices and Radiological Health (CDRH) prohibits the repair of laser-based 
optical units in the field. The optical housing unit can only be repaired in a factory or at a 
location with the requisite equipment. The laser subsystem is replaceable in the field by a 
qualified Customer Engineer. The laser chassis is not repairable in the field. Customer 
engineers are therefore directed to return all chassis and laser subsystems to the factory or 
service depot when replacement of the optical subsystem is required. 
 
  Use of controls, or adjustment, or performance of procedures other than those 
specified in this manual may result in hazardous radiation exposure. 
 
WARNING 
WARNING:   
Turn off the main switch before attempting any of the procedures in the Laser Optics 
Housing Unit section. Laser beams can seriously damage your eyes. 
CAUTION MARKING: 
 
Page of 127
Display

Click on the first or last page to see other DX-C200 service manuals if exist.