Read Sharp AR-SS2 Service Manual online
6. Connect the sorter connector.
Remove the sorter connector cover attached to the rear cabinet of the
copier.
copier.
Connect the sorter connector to the connector of the copier and
tighten the screw to fix the connector.
tighten the screw to fix the connector.
7. Attach the staple position label.
•
Attach the staple position label as shown below.
Insert the power plug of the copier into the power
outlet, turn on the power switch, and follow the
procedures below.
outlet, turn on the power switch, and follow the
procedures below.
8. Set the mode.
•
Set the mode with the key operation of the copier.
9. Check the operation of the staple sorter.
Align the paper to be stapled.
•
The max. stapling capacity is 30 sheets. If the max. capacity is
exceeded, a malfunction may occur.
exceeded, a malfunction may occur.
Set paper in the top bin, check the stapling position, and insert the
paper until it makes contact with the bin edge.
paper until it makes contact with the bin edge.
When the display lamp of the staple key is lighted, press the staple
key.
key.
Remove the paper in the top bin, and check that stapling is made
properly.
properly.
If stapling is not made, repeat the above procedures.
With the above procedures, installation of the staple sorter is com-
pleted.
pleted.
Sorter connector cover
Sorter connector
Screw
Connector of the copier
Staple position label A (for the copier)
Staple position label D (for the RADF)
The mode is set with the
above operations.
1
2
6
Select the corresponding
number with the 10-key.
Clear
P
C
CA
Copy (paper)
Stapling position
AR-SS2
2 – 4
Click on the first or last page to see other AR-SS2 service manuals if exist.