AR-RB1 (serv.man2). AR-RB1 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 5

AR-RB1  UNPACKING AND INSTALLATION  2 - 4

3) Attach the transport guide to the duplex bypass/inverter unit and

insert the two transport guide holders into the two transport guides
respectively. At this time, ensure that the transport guide holders
are secured at the notch positions.

4) After checking that the transport guide is aligned with the guide of

the stand, close the left cover of the main unit securely.

1) Remove the screw from the power supply cover on the rear side of

the optional stand and then remove the power supply cover.

2) Cut out the portion (indicated with H) of the removed power supply

cover shown in the illustration.

3) Connect the relay harness of the duplex bypass/inverter unit to the

connector of the optional stand.

Then, insert the snap band into the mounting hole shown in the
illustration to secure the relay harness.

4) Pass the relay harness through the cut out hole, hang the two

pawls of the power supply cover on the rear cabinet, and attach the
cover with the screw.

Installation of AR-RB1 is now complete.

Transport guide holders

 Front side

Rear side

Transport guide holder

Transport guide holder

Transport guide

Transport guide

Notch

Notch

Notches

 Power supply cover

Screw

Cut-out portion

Snap band

Relay harness

Connector

Power supply cover

Pawls

Screw

Relay harness