Read Sharp AR-PN1 Service Manual online
5-4
CHAPTER 5 TROUBLESHOOTING
COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON SADDLE FINISHER G1 REV.0 MAR. 2001
ON
1
2
3
4
1.2 Electrical System (puncher unit; option)
1.2.1 Adjusting the Punch Hole Position
This mode requires operation in service mode. The range of hole displacement is between
3 and -3 in 1-mm increments. A higher setting will move the hole toward the leading edge
of sheet. (See the Service Manual of the host machine.)
of sheet. (See the Service Manual of the host machine.)
1.2.2 Adjusting the Sensor Output
Perform the following when the punch controller PCB, horizontal registration sensor
(photosensor PCB/LED PCB), or waste full sensor (waste full photosensor PCB/waste full
LED PCB) has been replaced.
1) Shift bits 1 through 4 on the punch controller PCB as follows:
LED PCB) has been replaced.
1) Shift bits 1 through 4 on the punch controller PCB as follows:
F05-102-01
2) Press SW1002 or SW1003 on the punch controller PCB. A press will automatically ad-
just the sensor output.
•
The adjustment is over when all LEDs on the punch controller PCB are ON: LED1001,
LED1002, LED1003.
LED1002, LED1003.
3) Shift all bits of DIPSW1001 to OFF.
Chap05.p65
3/28/01, 12:11 PM
4
Click on the first or last page to see other AR-PN1 service manuals if exist.