Read Sharp AR-NC5J (serv.man2) User Guide / Operation Manual online
9
Appendix
Print Server Card
Users Manual
Method 2.
Continuously PING the IP address.
Print Server Card determines IP address in conditions below.
(1) Only one Print Server Card exists in the network
(2) It is in factory default (IP address is 0.0.0.0).
(3) More than 10 ARP request is thrown to Print Server Card within 1 minute.
(4) After ARP, the receiving packet is "ICMP Echo Request".
* Setting IP address in this method does not register IP address to Print Server Card, so it will
be erased with turning off the printer. After setting an IP address by this method, be sure to
register IP address by TELNET or utility.
* If there are more than one Print Server Card in the network while doing this method, you may
register same IP address to two Print Server Card. Be sure to setup only one by one.
Setup IP address using Method 2
IP address to be set: 192.168.20.28
1. Turn on the power of the Print Server Card.
2. PING command.
Ping 192.168.20.28
3. Continue PING command until you receive reply from Print Server Card. If you receive reply,
set up is completed.
(UNIX)
192.168.20.28 is alive.
(Windows95/98/Me, WindowsNT4.0, Windows2000 in DOS)
reply from 192.168.20.28: byte=32 time=xxms TTL=255
*
*
*
*
TIP
Click on the first or last page to see other AR-NC5J (serv.man2) service manuals if exist.