AR-NC1D (serv.man3). ARNC1D 3D NIC Manual - Sharp Copying Equipment User Guide / Operation Manual. Page 23

NetWare Configuration-7

Novell's NetWare 4.0x can operate in two modes NetWare Directory Services (NDS)
and Bindery Services Emulation. For Directory Services, see 4.3 Configuring the
Print Server Card in NetWare Directory Services. These services run simultaneously
and transparently to each other. The Print Server Card may be configured to operate
with Bindery Services mode only (this section), or to operate under NDS (4.3 Config-
uring the Print Server Card in NetWare Directory Services). When configured under
NDS, the print Server Card will also service older file servers operating in bindery
mode.

Note:   If the Print Server Card is not properly set up for NDS and the Bindery Services

mode is not running, the Print Server Card can not find its file servers, and the sta-

tus page indicates the Novell NetWare protocol is not active.

Before installing the Print Server Card on a Novell NetWare 4.x server in Bindery
Emulation mode, check that the server has a Bindery Context (name for the server
under Bindery Services mode). If the server does not have Bindery Context, it may be
preferable to install in NDS mode. If the Print Server Card must be installed in the
Bindery Emulation mode, the server must have Bindery Context.  Perform the follow-
ing steps to confirm the server has Bindery Context:

1. Go to the 4.x server and at the system console type: config

2. Press Return to continue the list.

3. If the server has Bindery Context the last entry in the list will display. 

Bindery Context(s):  and the name of the context.

4. If this is not displayed at the end of the config list consult the Novell NetWare 

manuals for instructions on how to set the Bindery Context.

Once you confirm the server has Bindery Context, use the following procedures to
configure the Print Server Card. 
1. Log into the network as ADMIN.
2. Type PCONSOLE and press the Return key. The following screen appears.