AR-NB3 (serv.man9). ARNB3 (Network Scanning Operation Manual) for when installed on AR-M165 or AR-M207. - Sharp Copying Equipment User Guide / Operation Manual. Page 36

When scanning takes place with the resolution set to the maximum resolution (600 dpi), the resolution may change 
depending on the amount of memory available, the original size, the colour mode, and other scanning conditions. The 
table below shows the relation between the possible scanning area and the scanning conditions. (Note that the following 
examples are for standard memory in the machine and 128 MB or more of memory in the network expansion kit.)

(dpi)

: Scanning is possible at the maximum resolution (600 dpi).

If a transmission error occurs when you send a scanned image, a message informing you of the error and an error 
code will appear in the display on the machine.

If a Scan to E-mail transmission is not successful, an e-mail informing you of this fact is sent to the return address configured 
in the SMTP server. If this happens, read the e-mail and determine the cause of the error, and then repeat the transmission.

A3

150

300

200

300

B4

200

400

A4, A4R

400

B5, B5R

300

300

A5, A5R

400

11" x 17"

150

300

300

300

8-1/2" x 14"

200

400

400

8-1/2" x 13"

8-1/2" x 11"

8-1/2" x 11"R

5-1/2" x 8-1/2"

5-1/2" x 8-1/2"R

300

400

CE-00
CE-01

Turn off the power and then turn it back on. Consult with your network administrator to 
make sure that no problems exist on the network or in the server. If the error is not 
cleared after turning the power off and on, turn off the power and contact your dealer.

–

CE-02
CE-04

The scanned image was not sent because a connection to the server could not be 
established. Make sure that the SMTP server settings or Scan to FTP destination 
settings in the Web page are correct.
The procedure for configuring the SMTP server is explained in "

", and the procedure for editing Scan to FTP destination information is 

explained in "

". For 

information on the settings to be entered, see Help in the Web page.

CE-03

The scanned image was not sent because the server was busy or there was too much 
traffic on line. Wait briefly and then try again.

–

CE-05

The scanned image was not sent because the directory of the destination FTP server was not 
correct. Make sure that the correct FTP server information is configured in the Web page.

CE-09

The size of the scanned image file exceeds the limit set in "Maximum Size of E-mail 
attachments" in the Web page. Reduce the number of original pages scanned into the 
file, or change the limit set in "Maximum Size of E-mail attachments".

CE-11

The memory became full during scanning. Scan less pages, lower the resolution, or 
change the colour mode so that the file size is smaller, and try scanning again.

CE-12

The maximum number of destinations of a global address search has been exceeded.
Increase the number of search characters to narrow the range of the global address search.