AR-M316 (serv.man10). ARM256 316 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 96

AR-M256/M257/M258/M316/M317/M318/5625/5631  SIMULATION 8 - 54

Select “1: YES” with the 10-key and press the [START] key. The FAST
storage data are cleared. (When “2: NO” is selected, the simulation is
canceled.)

Note: Executable only when the FAX is installed.

When the relay state of the polarity reverse relay, the handset hook
switch, or the external telephone hook switch is changed, the content
of change is displayed regardless of the soft SW setup (real time). The
display of change is kept until an interruption command is supplied by
pressing the [CUSTOM SETTINGS] key. 

Note: Executable only when the FAX is installed.

1.

Enter the set value. (Valid only 0 to 8)

2.

The entered bit is alternatively switched between “0” and “1” and
the target signal name is highlighted.

3.

Press the [START] key to send the signal. 

When the [CUSTUM SETTINGS] key is pressed, the output is terminated.

Note: Executable only when the FAX is installed.

The fixed data received from the line are checked and the result is displayed. 

When data are coincident, “OK” is displayed. When not, “NG” is displayed. 

Note: Executable only when the FAX is installed.

Signal detection is checked and the result is displayed. 

Note: Executable only when the FAX is installed.

The send/receive test is performed, and the time required for send/
receive of the image data in the test is measured and displayed.

66-24

Data clear

Used to clear the FAST storage data. (SEC only)

FAX

Data Initializing

66-30

Operation test/check

Used to set the TEL/LIU.

FAX

Operation

Item

Notification contents

Signal low

Signal high

HS2

ON

OFF

HS1

ON

OFF

RHS

ON

OFF

EXHS

ON

OFF

66-31

Setting

Used to set the TEL/LIU.

FAX

Operation

66-32

Operation test/check

Receive data check

FAX

Operation

66-33

Operation test/check 

Signal detection check 

FAX

Operation

66-34

Operation test/check 

Communication time measurement display

FAX

Operation

Setup on the user 
side when executing 
communication

Communication 
means
Picture quality
Density
ECM
Sender information

: Memory send
: Normal Character
: Lighter
: ON
: OFF

Measuring 
range

Send

From flag reception before sending of image 
data until sending of RCP frame

Receive

From flag reception before reception of 
image data until reception of RCP frame

Mode when measuring

Used to make communication not in a 
simulation process but in the normal screen 
and measure the time.

00001

1   2   3   4   5