AR-M276 (serv.man12). Key-Operator Manual - Sharp Copying Equipment User Guide / Operation Manual. Page 15

This program is used to select the respective output 
trays for the copy, printer, and fax functions.
One of four patterns, [PATTERN 1] through 
[PATTERN 4], can be selected.
Example: When a FINISHER is installed

This program is used to enable or disable the offset 
functions of the center tray and offset tray (when a 
FINISHER is installed).

This program is used to set the amount of IMC 
memory that is allocated to the printer function. The 
amount of memory can be set from 30% to 70% in 
increments of 10%.

●

Memory allocated to print hold
(When the PRINTER EXPANSION KIT is installed)
To set the amount of memory allocated to print hold, 
touch the [THE MEMORY AREA FOR PRINT 
HOLD] key. The amount of memory can be set from 
30% to 70% in increments of 10%. If 0% is selected, 
the print hold function cannot be used.

This program is used to disable counting of pages 
delivered to the center tray.
When this program is enabled, center tray full 
detection does not take place.

This program is used to set the amount of time that 
must elapse after a copy job is finished before the 
printer or fax function resumes operation. The amount 
of time can be set from 1 second to 60 seconds in 
increments of 1 second.

When this program is enabled, originals of mixed 
length (the widths must be the same) can be scanned 
in copy mode and each original copied onto the 
corresponding length of paper.

PATTERN 1

Copy: Offset tray
Printer: Center tray
Fax: Top tray

PATTERN 2

Copy: Center tray
Printer: Offset tray
Fax: Top tray

PATTERN 3
(When the fax 
function is enabled)

Copy: Center tray
Printer: Offset tray
Fax: Center tray

PATTERN 4
(When the fax 
function is enabled)

Copy: Offset tray
Printer: Center tray
Fax: Center tray