AR-M165-207 (serv.man24). Operation Manual (for Printing and Scanning)when ARNB3 (Network Printing and Scanning Option) is not installed. - Sharp Copying Equipment User Guide / Operation Manual. Page 31

If you find that a notice page has been printed at the end of a print job, the print data received from the computer has 
not been printed as specified. Fix the problem as explained below and then try printing again.

The above notice page is printed when a print job 
containing more data than can be held in the memory 
of the dual function board is sent. Deactivate the 
ROPM function by removing the checkmark from 
[ROPM] in the [Configuration] tab of the printer driver 
setup screen. If you need to use the ROPM function, 
set the "Print quality" in the printer driver to [Draft], or 
increase the amount of memory in the machine.

****************************************************

Notice Page

****************************************************

The IMC memory full error had occurred,

a normal output was not able to be executed.

Please refer to the operation manual for

the solution method.

• The Notice Page can be set to not print 

out in 

 of the 

key operator programs.

• The memory of the dual function board is used 

to temporarily hold print data when the ROPM 
function is used. This memory is also used to 
temporarily store the image of the original during 
copying. The proportion of memory allocated to 
the printer function can be changed in the key 
operator programs. See the "Key operator's 
guide". The memory can also be increased by 
adding the optional memory modules. For 
details, contact your SHARP dealer.

• A notice page such as "The incorrect driver 

is chosen, a normal output was not able to 
be executed....." will be printed if you 
attempt to print using the print driver for the 
dual function board. Install the standard print 
driver as explained in "1. INSTALLING THE 
SOFTWARE (THAT ACCOMPANIES THE 
MACHINE)" in the "Software setup guide" 
and select the standard driver when printing.

→ Clean regularly.

Operation manual (for 

general information 

and copier)

→ Use a clean original.

–

→ Make sure that the resolution setting in the scanner driver is 

appropriate for the original.

→ If you attempt to scan a large area at high resolution and there is insufficient 

memory in the machine to hold the scanned data, scanning will take place at 
a lower resolution and the scanner driver will enhance the data to make up 
for the lower resolution. However, the quality of the enhanced image will not 
be as high as if scanning took place at the higher resolution. To scan a 
ledger or A3 original in full color at 600 dpi without using enhancement, the 
dual function board and 256 MB memory option are required. 

→ If you are using a TWAIN-compliant application and are using 

[White], [Red], [Green], or [Blue] for "Light Source" in the TWAIN 
driver, make sure that the "B/W Threshold" setting is appropriate. A 
larger threshold value makes your output darker, while a small 
threshold value makes it lighter. To adjust the threshold 
automatically, click the [Auto Threshold] button on the [Image] tab of 
the "Custom Settings (or Professional)" screen. 

–