AR-M165-207 (serv.man19). General Information and Copier Operation Manual - Sharp Copying Equipment User Guide / Operation Manual. Page 10

Improper installation may damage this product. Please note the following during initial installation and whenever the 
machine is moved.

1. The machine should be installed near an accessible power outlet for easy connection.
2. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current 

requirements. Also make certain the outlet is properly grounded.

• For the power supply requirements, see the name plate on the back of the main unit.

3. Do not install your machine in areas that are:

• damp, humid, or very dusty 
• exposed to direct sunlight 
• poorly ventilated 
• subject to extreme temperature or humidity changes, e.g., near 

an air conditioner or heater.

4. Be sure to allow the required space around the machine for 

servicing and proper ventilation.

Connect the machine to a power outlet which is not used for other electric appliances. If a lighting fixture is 
connected to the same outlet, the light may flicker.

A small amount of ozone is produced within the printer during operation. The emission level is insufficient to cause any health 
hazard.

The present recommended long term exposure limit for ozone is 0.2 mg/m

3

 (0.1 ppm) calculated as an 8 hr. time-weighted 

average concentration.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a 
ventilated area.

As an ENERGY STAR

®

 Partner, SHARP has determined that this product meets the ENERGY 

STAR

®

 guidelines for energy efficiency.

20 cm (8")

20 cm

(8")

20 cm

(8")