AR-LC1 (serv.man2). ARLC1 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 5

Remove the connector cover securing screw for connection of the
large capacity tray relay harness connector and remove the connec-
tor cover.Then connect the large capacity tray relay harness connec-
tor to the connector of the copier and tighten the screw on the con-
nector to secure the connector.

Pull out gently the paper tray of the large capacity tray until it
stops.Remove the feed table securing screw and 5 securing materials
which secure the feed table of the large capacity tray.

Push back gently the paper tray to its original position.

To use the large capacity tray without changing the paper size from
the factory default setting:

★

Proceed to step 12 of this installation manual.

At this time, insert the power plug of the copier to an outlet and turn
the power switch to the "ON" position.

★

Factory default setting: A4 size

The paper size can be switched only to the B5 size.

To use the large capacity tray after changing the paper size from the
factory default setting:

Pull out gently the paper tray until it stops and remove the stopper
securing screw located on the lower part of the right side to remove
the stopper.

Then pull out again the paper tray until it stops.

Remove each rear end shaft securing screw (blue) which secures the
rear end shaft to the right side in the paper tray and remove the 2
rear end shafts.

Then fit the lower part of each removed rear end shaft to the mount-
ing hole of the feed table of the paper tray and secure the upper part
to the position with B5 indication using a securing screw (blue).

Securing screw

Connector cover

 Screw

Connector

Securing materials

Securing materials

Feed table securing screw

Feed table

Stopper

Securing screw

Rear end shafts

Securing screw (blue)

Securing screw (blue)

Securing screw (blue)

Rear end shafts

Feed table

 Mounting holes

3 – 3