Read Sharp AR-FX12 (serv.man7) Service Manual online
AR-FX12 UNPACKING AND INSTALLATION 5-1
[5] UNPACKING AND INSTALLATION
<Before installation>
• For installation of AR-FX12, the control PWB unit and the scanner unit
must have been installed.
• Start installation after checking that the COMMUNICATION indictor on
the operation panel is neither lit nor blinking.
Then remove the power plug of the main unit from the outlet.
<1>Remove the scanner cable from the control PWB unit.
<2>Remove the five screws that secure the control PWB unit to the main
unit.
<3>Hold the two grips and pull out the control PWB unit until it is stopped
by the stopper.
<4>Remove the connector of the flat cable.
<5>While unlocking the stopper with your finger, pull the control PWB
<5>While unlocking the stopper with your finger, pull the control PWB
unit to remove it from the main unit.
Remove the two screws that secure the FAX I/F cover of the control
PWB unit and remove the FAX I/F cover.
PWB unit and remove the FAX I/F cover.
<Procedure for mounting additional memory (AR-MM9)>
* If mounting of additional memory is not needed, proceed to step 5.
Mount the additional memory to the socket located on the back side
of the interface PWB unit.
Connect the fax interface PWB unit to the fax interface PWB
connector (100 pins) of the control PWB unit and secure it with two
screws C.
<1>Reattach the control PWB unit to the main unit.
<2>Connect the flat cable that has been removed in step 2)-<4> to the
connector.
<3>Push the control PWB unit into the main unit and secure it with the
five screws.
1)Turn off the power switch of the main unit.
2)Pull out the control PWB unit.
3)Remove the FAX I/F cover.
4)Mount the additional memory.
5)Attach the fax interface PWB unit.
6)Reattach the control PWB unit.
[05]UNPACKINGANDINSTALLATION.fm 1 ページ ２００４年１２月１５日 水曜日 午後２時１５分
Click on the first or last page to see other AR-FX12 (serv.man7) service manuals if exist.