Read Sharp AR-FN6 Service Manual online
AR-FN6 UNPACKING AND INSTALLATION-1
[4] UNPACKING AND INSTALLATION
<Before installation>
• For installation of AR-FN6, an optional stand/paper drawer (stand/MPD
& 2000 sheet paper drawer, stand/3 x 500 sheet paper drawer or multi
purpose drawer) must have been installed.
purpose drawer) must have been installed.
Also if a multi purpose drawer has been installed, a power supply unit
(AR-DC1) is needed additionally.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the main unit to the
"OFF" position.
Then, remove the power plug of the main unit from the outlet.
2) Remove the upper cabinet of the stand/paper drawer.
<1>Pull out the paper tray of the stand/paper drawer.
<1>Pull out the paper tray of the stand/paper drawer.
Remove the four screws of the cabinet attached to the right side of
the main unit of the printer and remove the cabinet.
<2>Mount screw B to the position shown in the illustration.
3) Attach the finisher.
<1>Remove the paper exit actuator from the main unit of the printer.
<1>Remove the paper exit actuator from the main unit of the printer.
<2>Raise the relay unit at the side of the finisher.
<3>Put the finisher on the stand/paper drawer.
Put the finisher on the stand/paper drawer temporarily and push the
lower part to slide to the exit tray section of the main unit and to
attach the finisher.
<4>Open the front cover of the finisher and fix the finisher with three
screws A at the positions shown in the illustration.
Then, close the front cover and close the paper tray of the stand/
paper drawer.
paper drawer.
<Parts included>
Mounting plates: 2 pcs.
Staple cartridge: 1 pc.
Tray 1: 1 pc.
Paper holder: 1 pc.
Screws A: 5 pcs.
Screw B: 1 pc.
Tray 2: 1 pc.
"OFF"
Cabinet
Screw B
Actuator
Relay unit
1
2
Screws A
Screws A
(Front side)
Click on the first or last page to see other AR-FN6 service manuals if exist.