Read Sharp AR-FN5 (serv.man2) Service Manual online
C. Rear edge plate solenoid
Refer to Fig.(7-3).
8-3
8-4
D. Shutter drive solenoid
Refer to Fig.(7-3).
8-5
E. Transport switch gate solenoid
Refer to Fig.(1-A-1) to (1-A-5).
Refer to Fig.(6-1) to (6-2).
Refer to Fig.(6-1) to (6-2).
8-7
[6] ADJUSTMENTS
Adjustments are required when replacing the following parts:
A. Rear edge plate unit
B. Side guide plate
C. Gate solenoid right
D. Gate solenoid left
E. Upper alignment solenoid
F. Shutter solenoid
G. Rear edge plate solenoid
H. Paper holding solenoid
A. Rear edge plate unit
1. Staple 5 sheets of A4 or LT paper, and check the slide shift of the
paper bundle in the transport direction (Y-axis).
2. When the shift of the paper bundle is within 1mm, there is no need
to adjust.
3. If the shift of the paper bundle is greater than 1mm, execute SIM
3-6-3 to adjust the rear edge plate position.
B. Side guide plate
1. Staple 5 sheets of A4 or LT paper, and check the slide shift of the
paper bundle in the vertical direction (X-axis) to the transport direc-
tion.
tion.
2. When the shift of the paper bundle is within 1mm, there is no need
to adjust.
3. If the shift of the paper bundle is greater than 1mm, execute SIM
3-6-2 to adjust the side guide plate position. Also check that the
paper bundle is in parallel with the alignment reference wall of the
side guide plate.
paper bundle is in parallel with the alignment reference wall of the
side guide plate.
SIM 3-6 Finisher alignment member adjustment
When a sub code is entered, the above display is shown.
1. In SIM 3-6-1, press [OK] and select [1] - [10] to specify the paper
size.
2. Enter SIM 3-6-2 Jogger pos X (side guide plate) or SIM 3-6-3
Jogger pos Y (rear edge plate) and press [OK]. The alignment
section (rear edge plate unit), side guide plate) will be operated.
During the load operation, the [OK] key is highlighted.
section (rear edge plate unit), side guide plate) will be operated.
During the load operation, the [OK] key is highlighted.
3. Keep the alignment member at the paper alignment position, and
open the alignment section. Insert paper of the same size into the
alignment member and check that the tightness is proper. 1~2 mm
smaller (tight) than the paper size is O.K.
alignment member and check that the tightness is proper. 1~2 mm
smaller (tight) than the paper size is O.K.
4. When the adjustment value of the simulation is decreased by 1,
the clearance between paper and the side guide plate is de-
creased by 0.41mm, and between paper and the rear edge plate
0.83mm, and vice versa.
creased by 0.41mm, and between paper and the rear edge plate
0.83mm, and vice versa.
1)
2)
4)
3)
5)
1)
2)
1)
2)
3)
4)
1)
2)
Sim3-6 JOGGER ADJ.
1:PAPER SIZE
2:JOGGER POS X
3:JOGGER POS Y
1
(Initial screen)
Click on the first or last page to see other AR-FN5 (serv.man2) service manuals if exist.