AR-C260 (serv.man8). (5) Unpacking Installation - Sharp Copying Equipment Service Manual (repair manual). Page 6

AR-C260/C260M  UNPACKING AND INSTALLATION  5 - 6

5) Insert the cartridge securely until it locks.

6) Return the cartridge lever to the original position.

7) Close the front cover.

1) Insert the AC power plug into the connector at the rear of the

machine, and connect the other end to the power outlet.

1) Turn on the power switch on the left side of the machine.

Used to set the specifications with SIM26 according to the customer's
request.

To customize the following items after completion of the destination
setup, change the set values.

On completion of the installation of the AR-F13 finisher, please change
the default output tray of the machine to the top tray of the finisher.

Check the following items related to image quality. For details of the
adjustment and checking procedures, refer to the chapter of adjust-
ments.

1) Image focus, image skew (Refer to ADJ 3.)

2) Image registration (Refer to ADJ 4.)

3) Image loss, void area (Refer to ADJ 10.)

4) Copy color balance, density (Refer to ADJ 11.)

Check that the above items are normal. If not, make the adjustment.

Check that the following operations are normal.

Do not press
this section. 
(If it is pressed, 
the lock lever 
falls.)

1

2

SIM No

Content

26

6

Used to set the destination. 

SIM No

Content

26

2

Used to set the large capacity paper feed tray paper size.
Used to set the detection paper size and display when 
using 8.5 x 13 size paper and document.
Used to set the paper kind and the display form in the 
manual paper feed mode.

3

Used to set the auditor specification mode.

5

Used to set the count mode of the total counter and the 
maintenance counter.

18

Used to set YES/NO of the toner save mode (Only in UK 
and Japan versions) For other destination versions, this 
setup is made by the user program.

52

Used to set YES/NO of counting when non-print paper is 
passed through each counter.

53

Used to set YES/NO of user calibration permission.

65

Used to set the limit number of sheets for stapling.

Check item

Installation

Key input operation (Operation 
panel)

Display (Operation panel)
Paper feed 
operation

Manual paper 
feed
Machine paper 
tray
Desk unit 
paper feed tray

When the desk unit is installed.

Large capacity 
paper feed tray

When the large capacity paper 
feed tray is installed.

Paper size detection operation

Document 
size detection 
operation

Document 
table mode

RADF mode

When the RADF is installed.

RADF 
operation/
Duplex copy 
operation

S-S mode

When the RADF is installed.

D-S mode

When the RADF is installed.

S-D mode

When the 
RADF is 
installed.

When the desk 
unit with the 
duplex unit is 
installed. 

D-D mode

When the 
RADF is 
installed.

When the desk 
unit with the 
duplex unit is 
installed.