AR-C260 (serv.man33). AR-C260 Key Operators guide - Sharp Copying Equipment User Guide / Operation Manual. Page 9

■ Energy save

For saving energy, two programs are provided for
reducing the user's electricity bill, reducing waste
of natural resources and cutting down on
environmental pollution. In situations where it is
impractical to use the Auto power shut-off timer, a
program is provided to cancel that function.
A program is also provided for reducing toner
consumption.

Printing in the toner save mode will reduce black
toner consumption. If toner save is set, black solid
areas will be printed as halftone. (This setting is
effective only for printing without use of the printer
driver. If the printer driver is used, the printer driver
setting will override the setting of this program.)

This program is used to save toner in copy mode.
This program functions the same way as toner
save in B/W printer mode.

When a programmed length of time has elapsed
without any operation after printing is complete, the
printer will enter the auto power shut-off mode to
save the maximum amount of energy.
The time until auto power shut-off occurs can be
set in 1 minute increments up to 240 minutes.

When a programmed length of time has elapsed
without any operation after printing is complete, the
printer enters the auto power shut-off mode to save
the maximum amount of energy. If it becomes
impractical to use the shut-off feature, this program
can be used to disable the feature. If disabled, the
auto power shut-off time setting (described above)
will be ignored.

The printer will enter the preheat mode after a
programmed length of time has elapsed without
any operation after printing is complete. We
suggest you set the most appropriate time
according to your usage pattern.
The time until the unit enters the preheat mode can
be set in 1 minute increments up to 240 minutes.
Note that this function cannot be disabled.

■ Operation settings

These programs are used to adjust the display on
the operation panel.

This setting is used to select whether or not a
sound is made when a key is touched. Normally a
sound is made when a key is touched.

After a programmed length has elapsed without
any operation after a copy job is complete or while
detailed status information is being displayed, the
auto clear function will return the screen to the copy
main screen or the job status screen. The auto
clear time can be set in 10 second increments up to
240 seconds. The auto clear function can be
disabled for copier functions.

This program is used to change the language of
messages displayed on the operation panel.

This program is used to adjust the time that
messages are displayed (for messages that
automatically disappear).
The time can be set in 1 second increments up to
12 seconds.

NOTES
● We suggest you set the most appropriate time

according to your usage pattern.

● If you use the program "Auto power shut-off"

(described below) to disable the auto power
shut-off mode, the time set with this program will
be ignored.

Print data

Example of 
print in the 
toner save 
mode

Rather than disabling the auto power shut-off
feature, we suggest that you first try lengthening
the time setting of the auto power shut-off timer. In
most cases a suitable timer setting will allow work
to proceed with minimal delay and still enable you
to enjoy the benefits of power conservation.

sec_whale_keyope.fm  8 ページ  ２００２年１１月２６日　火曜日　午前１０時５８分