Read Sharp AR-C160 (serv.man51) Technical Bulletin online
GMA050702
Sharp Electronics (UK) Ltd., Technical Services Group
You can check and compare the result of your adjustment by pressing “EXECUTE”,
which prints a current test pattern.
Once the composite black strip (4 colour) has been adjusted, so that it is as close to
the process black channel, exit the test simulation.
In addition to suit customer requirements, the colour balance for each colour
exposure mode can be adjusted by using Test Simulations 46-10/11/12/13/14 .
These simulations are identical to test simulation 46-21, except there is no
“EXECUTE” key. Use the Sharp colour test chart or customer samples, and switch
between the test command and the user exposure selection to make adjustments.
Press “CLOSE” to leave the simulation, make a test copy after selecting the
appropriate exposure mode. Press, “TEST” to return to the test simulation and
make further adjustments.
To save ALL Half Tone adjustments, execute Test Simulation 44-21. Once
complete, enter simulation 44-06 to perform compulsory engine process control:-
Press “EXECUTE”.
The “COMPLETE” box will be highlighted if process control has been performed
successfully.
If an “ERROR” occurs, repeat the simulation once, then diagnose the cause of the
error.
Using the Sharp Colour Test Chart (UKOG-0283FCZZ), make test copies and
confirm copy quality.
This concludes the colour balance adjustment(s).
Copy Exposure
Test Simulations 46-01 & 46-02
The exposure adjustment in ALL colour and B/W modes must be performed
after calibrating the engine. Failure to check or adjust the copy exposure may
result to excessive background when copying.
after calibrating the engine. Failure to check or adjust the copy exposure may
result to excessive background when copying.
Cont’d
Click on the first or last page to see other AR-C160 (serv.man51) service manuals if exist.