Read Sony DAV-DZ290K / DAV-DZ295K / DAV-DZ390K / DAV-DZ590K / DAV-DZ690K / DAV-DZ790K / HCD-DZ295K / HCD-DZ390K / HCD-DZ590K / HCD-DZ690K / HCD-DZ790K Service Manual online
DZ295K/DZ390K/DZ590K/DZ690K/DZ790K.
Surround mode (reference) RMS output power
FL/FR/C/SL/SR*:
Surround mode (reference) RMS output power
FL/FR/C/SL/SR*:
source, there may be no sound output.
DZ290K/DZ295K/DZ390K/DZ590K/DZ690K:
TV/VIDEO (AUDIO IN) Sensitivity: 450/250 mV
AUDIO IN/MIC
TV (AUDIO IN)
AUDIO IN/MIC
DZ390K/DZ590K/DZ690K:
TV/VIDEO (COAXIAL IN/OPTICAL IN)
TV (COAXIAL IN/OPTICAL IN)
Phones
of 200mm from the objective lens surface on the
Optical Pick-up Block with 7mm aperture.
DZ290K/DZ295K/DZ590K/DZ790K:
Mexican and Latin American models:
NTSC
Other models:
FM Tuner section
Tuning range
North American models: 87.5 MHz - 108.0 MHz
Intermediate frequency
(II) adaptive matrix surround decoder and the DTS** Digital Surround
System.
* Manufactured under license from Dolby Laboratories.
Laboratories.
and worldwide patents issued & pending. DTS and DTS Digital
Surround are registered trademarks and the DTS logos and Symbol
are trademarks of DTS, Inc. © 1996-2008 DTS, Inc. All Rights
Reserved.
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
North American and Mexican models:
50/60
DZ290K/DZ295K/DZ590K/DZ690K/DZ790K:
On:
DC
700
The components identifi ed by mark 9 contain confi dential infor-
mation.
Strictly follow the instructions whenever the components are re-
paired and/or replaced.
MP3 (MPEG 1 Audio Layer-3)
DRM: Not
without notice.
– Back Panel –
AR :
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
• Unleaded solder melts at a temperature about 40 °C higher
applied to the solder joint for a slightly longer time.
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
also be added to ordinary solder.
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
• Keep the temperature of soldering iron around 270 °C during
exceeding the limit for Class 1.
a CLASS 1 LASER product.
This marking is located on the
rear or bottom exterior.
Use of controls or adjustments or performance of procedures
other than those specifi ed herein may result in hazardous radia-
tion exposure.
(JEITA).)
Recording) mode
DL)
• CD-R/CD-RW/CD-ROM in video CD
ISO 9660
format, containing MP3 files
UDF (Universal Disk Format)