Read Sharp AR-BD14 (serv.man5) Service Manual online
9) In SIM 67 (Flash memory self-diagnosis), select "14.PROGRAM
W/V" (SIM 67-14).
10) The display shows "PLEASE SEND FONT DATA FROM PER-
SONAL COMPUTER" and the AR-5132 enters the waiting mode
for the data sending from the personal computer.
for the data sending from the personal computer.
11) ON the DOS mode or the DOS window of the Windows, execute
the following command:
copy/b filename lptl:
*
Enter the file name of the version-up flash ROM writing data
(program data) to "filename" in the above command.
(program data) to "filename" in the above command.
12) The display shown "WRITING/VERIFYING IN PROCESS" and
writing and comparison of the flash ROM data are performed.
13) After a while, data sending from the personal computer is ter-
minated, but writing to the PRT board is not terminated. Wait
until writing and comparison are completed.
until writing and comparison are completed.
14) When writing and comparison are normally completed, the dis-
play shows "PROGRAM DATA WRITING/VERIFYING OK."
15) At that time, the byte number of the data received from the
personal computer is also displayed.
16) Press the CA key to terminate the simulation. (The AR-5132 is
reset.)
17) After resetting, use SIM 22-14 to check the PRT version and
confirm that the version has been revised.
<When writing is not completed normally>
If writing and comparison of the PRT board is not completed
normally, the display shows "PROGRAM DATA
WRITING/VERIFYING NG."
In this case, check connection, the file name, etc. and repeat
the procedure from 4).
If writing and comparison of the PRT board is not completed
normally, the display shows "PROGRAM DATA
WRITING/VERIFYING NG."
In this case, check connection, the file name, etc. and repeat
the procedure from 4).
(Note)
The PRT version number displayed when SIM 22-14 is ex-
ecuted is not revised until the AR-5132 is reset. In procedure
13), therefore, be sure to press CS key to reset the AR-5132
before checking the revised version number.
ecuted is not revised until the AR-5132 is reset. In procedure
13), therefore, be sure to press CS key to reset the AR-5132
before checking the revised version number.
18) Turn off the power and disconnect the power plug of the copier.
19) Mount the ICU board cover.
Replace the ICU board cover which has been removed in step 3
to its original position and secure it with three screws.
to its original position and secure it with three screws.
At this time, check that the two pawls of the ICU board cover fit
the mounting positions between the frame and the upper right
side panel of the copier.
the mounting positions between the frame and the upper right
side panel of the copier.
20) Mount the right side panel.
Replace the right side panel which has been removed in step 2
to its original position and secure it with the three screws.
to its original position and secure it with the three screws.
At this time, check that the right side panel fits securely the
copier.
copier.
Close the toner collecting container cover, manual feed tray, and
side cover.
side cover.
ICU board cover
Pawl
Upper right side panel
Screws
Pawl
Right side panel
Manual feed tray
Toner collecting
container cover
container cover
Side cover
Screws
Screw
– 42 –
Click on the first or last page to see other AR-BD14 (serv.man5) service manuals if exist.