Read Sharp AR-810 (serv.man13) Service Manual online
AR-651/810 PAPER FEEDING SECTION 9 - 19
(13)Remove 1 screw and take off the plate spring.
(14)Remove 1 screw (as shown with the white arrow)
from the back side and release the bracket.
Bracket
Earth plate spring
Note: When installing the bracket, install it so that the
pointer of the bracket comes to the position where
it has been before being removed.
Notes: Pay attention to the following things when setting
up the bypass feed roller and pickup roller.
1. Put the clip in the groove of the shaft
completely.
2. Make sure there is no adhesion of oil and
such on the timing belt, pulley and roller.
3. Be careful not to install the bypass pickup
roller and feed roller in a wrong direction.
4. Install the feed roller for the one-way clutch
to come to the rear side.
Feeding
direction
direction
Separation roller
Feed roller
Pickup roller
Pointer
(15)Disconnect 1 connector, remove 1 screw and
take off the paper size detection sensor board.
Paper size detection sensor board
Connector
Click on the first or last page to see other AR-810 (serv.man13) service manuals if exist.