Read Sharp AR-810 (serv.man13) Service Manual online
AR-651/810 PAPER FEEDING SECTION 9 - 17
(6) Remove 1 clip, disconnect 1 connector, take off
1 harness band and release the bypass feed
clutch.
Bypass feed clutch
Clip
Harness band
(8) Disconnect 1 connector and remove 2 screws
to take off the solenoid.
Notes: 1. When installing the solenoid, install it for the
edge of the solenoid to get in phase with the
edges of the plate.
Spring
2. When installing the solenoid, fix it at the
position where the bosses of two gears are
put each other.
3. Put on the spring in the place shown by the
figure.
Bosses
(7) Remove 5 screws, disconnect 1 connector and
take off the stay.
Connector
Click on the first or last page to see other AR-810 (serv.man13) service manuals if exist.