Read Sharp AR-651 (serv.man19) Service Manual online
AR-651/810 RADF (DOCUMENT FEEDER) 16 - 67
This is a circuit to connect to COM with one of the four analog input signals. As following table shows,
the digital signals input into IC7-11pin(A), IC7-10pin(B) and IC7-9pin(C) switch the corresponding chan-
nels and IC7-3pin(COM) at a high speed, and they are input into the A-D input terminal of CPU. Each
channel signal is an analog output signal of the reflective sensor and used to adjust the sensor auto-
matically.
(9) Conversion circuit for D-A
This is a circuit of the D-A converter to converse the digital signal from CPU to the analog signal.
Controls of CPU are done by the serial communications of each DI, CLK, LD signal. The analog output
signals from Ao1 to Ao4 are used to adjust the light intensity of the light emitting diode (LED) of the
reflective sensor. Also, Ao5 and Ao6 output 5V or 0V and are used as the output ports.
(10) Analog multiplexer circuit
C B A
Corresponding Channel
L L L
0
L L H
1
L H L
2
L H H
3
Click on the first or last page to see other AR-651 (serv.man19) service manuals if exist.