AR-203 (serv.man5). AR203 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 121

AR-203E/5420/M200/M201  USER PROGRAM  12 - 4

*

1

: The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED", however, the printing speed does not increase considerably.

*

2

: When the 250-sheet paper feed unit is installed.

19

AE LEVEL ADJUST

1: SPF/RSPF 

(Adjustment to 5 levels 
is possible.)

2: DOCUMENT GLASS 

(Adjustment to 5 levels 
is possible.)

• This is used to adjust the exposure level.
• The automatic exposure level can be adjusted separately for the document

glass and the RSPF.

• For the procedure for adjusting the exposure and guidelines for numeric

values. The factory default setting for the exposure level is center.

20

LANGUAGE

1: AMERICAN  ENGLISH
2: ENGLISH
3: FRENCH
4: SPANISH

:
:

• This is used to set the language used in the display.

21

RESET FACTORY

1: Yes
2: No

• This is used to return all settings to the factory default settings.

22

SORT AUTO 
SELECT

1: ON
2: OFF

• Use this setting to enable or disable sort auto select mode.

24

CHECK RSPF 
OPEN

1: ON
2: OFF

• You can set the operation that takes place if the [START] key (

) is

pressed when the RSPF is not completely closed. (Valid only when the
multi-bypass paper feed is used.)

25

VALID COPY 
WIDTH

1: 8.5x11
2: 5.5x8.5

• Set the allowed paper sizes for copying from the bypass tray. When

"5.5x8.5" is selected, a copy of a letter size original will only be printed up
to invoice size.

28

LSU SETTING

1: ON
2: OFF

• Select whether copying is only allowed when the polygon motor is rotating,

or also when the polygon motor is stopped.

29

PAPER TYPE

1: PLAIN PAPER
2: HEAVY PAPER

• Set the temperature of the fusing unit when the bypass tray is used.

Normally "HEAVY PAPER" should be selected.

30

DISPLAY 
CONTRAST

1: LIGHTER
2: LIGHT
3: NORMAL
4: DARK
5: DARKER

• Set the contrast of the display.

Program 

number

Program name

Setting codes

(factory default setting 

appears in bold)

Explanation

Program 

number

Program name

Setting codes

(factory default setting 

appears in bold)

Explanation

1

FORCED OUTPUT

1: ON
2: OFF

• When this function is enabled, printing in printer mode will automatically

continue using a different size of paper if the specified size of paper runs out
in all trays. This feature does not function in copy mode.

2

USB 2.0 MODE 
SWITCH *

1

1: FULL-SPEED
2: HI-SPEED

• This sets the USB 2.0 data transfer speed. To obtain the fastest speed when

using the USB 2.0 connector, first verify that your computer meets the
system requirements (operating system and driver), and then use this
program to change the USB 2.0 mode to "Hi-Speed". Note that the setting
should not be changed while running a TWAIN driver.

3

AUTO  TRAY 
SWITCH*

2

1: ON
2: OFF

• If the paper runs out during printing and there is paper of the same size in

another tray, this function automatically switches to that tray (excluding the
bypass tray). The function can be disabled.