Read Sharp AL-1622 (serv.man8) Service Manual online
AL-1611/AL-1622
UNPACKING AND INSTALLATION
5 – 4
4) Move the left guide to the appropriate slot as marked on the tray.
• When using 11”
×
17” copy paper, store the left guide in the slot at the
left front of the paper tray.
5) Load copy paper into the tray.
6) Place the paper size plate in the front of the paper tray.
• The paper size indication which shows through the slot on the front of
the copier should match the selected paper size.
7) Push the paper tray firmly back into the copier.
8) To set the selected paper size, press the PAPER SIZE ENTER
(
) key.
• The selected paper feed location indicator will blink and the corre-
sponding paper size (which is currently set) indicator will light up
steadily. All other indicators except the START (
steadily. All other indicators except the START (
) key indicator
will go out.
Note: If copying is being performed, paper size setting cannot be made.
9) AL-1622 only Use the TRAY SELECT (
) key to select the paper
tray of which the paper size has been changed.
• Each time the TRAY SELECT (
) key is pressed, a paper tray will
be indicated with a blinking paper feed location indicator.
10) Use the ORIGINAL SIZE ENTER (
) key to select the
paper size which is set in the paper tray.
• Each time the ORIGINAL SIZE ENTER (
) key is pressed,
a paper size will be indicated with a paper size indicator.
11) Press the START (
) key and then the PAPER SIZE ENTER
(
) key.
• AL-1622 only To change the paper size setting of the other tray,
repeat steps 9 to 10 after pressing the START (
) key.
