Read Sharp AL-1622 (serv.man25) User Guide / Operation Manual online
61
GENERAL INFORMA
TION
MOVING INSTRUCTIONS
When moving this copier, follow the procedure below.
When moving this copier, be sure to remove the TD cartridge in advance.
TD cartridge lock
release lever
release lever
1
Turn the power switch off and disconnect the power
cord.
cord.
2
Open the bypass tray. Lift slightly on the side cover
and slide the cover out until it stops.
Push gently on
both sides of the front cover and open it.
3
Lift the TD cartridge lock release lever and pull the
cartridge out until the green strap handle can be grasped
by the right hand. Lift the cartridge by the handle while
supporting it with the left hand at the green label position
to remove it.
cartridge out until the green strap handle can be grasped
by the right hand. Lift the cartridge by the handle while
supporting it with the left hand at the green label position
to remove it.
4
Close the front cover by pushing both sides with your
hands and then close the side cover by pressing the
handle on the cover.
hands and then close the side cover by pressing the
handle on the cover.
When closing the covers, be sure to close the front
cover securely and then close the side cover. If the
covers are closed in the wrong order, the covers may
be damaged.
cover securely and then close the side cover. If the
covers are closed in the wrong order, the covers may
be damaged.
5
Gently lift and pull out the paper tray until it stops.
6
Push the centre of the pressure plate down until it locks
in place and lock the plate using the pressure plate lock
which has been stored in the front of the paper tray.
in place and lock the plate using the pressure plate lock
which has been stored in the front of the paper tray.
7
Use a coin (or suitable object) to attach to the left side
of the copier the screw that has been stored in the front
of the paper tray (upper paper tray in AL-1622).
of the copier the screw that has been stored in the front
of the paper tray (upper paper tray in AL-1622).
When shipping the copier, the screw must be reinstalled
to prevent shipping damage.
to prevent shipping damage.
8
Push the paper tray back into the copier.
●
For AL-1622, repeat steps 5, 6, and 8 for both the upper and lower
trays.
trays.
9
Close the bypass tray. Attach the packing materials and
tape which were removed during installation of the
copier. See page 11, SET-UP.
tape which were removed during installation of the
copier. See page 11, SET-UP.
10
Pack the copier into the carton. See page 10, CHECKING
PACKED COMPONENTS AND ACCESSORIES.
PACKED COMPONENTS AND ACCESSORIES.
Moving instructions
Click on the first or last page to see other AL-1622 (serv.man25) service manuals if exist.