PN-L802B (serv.man10). Pen Software - Sharp Monitor User Guide / Operation Manual. Page 22

22

E

You can customize various settings of this software.

The settings are the same in both whiteboard mode and overlay mode. However, the contents of the screen will vary depending 

on which mode is started.

(5)

(12) *

1 

(1)

(2)

(3)

(4)

(6)*

1

(7)*

1

(8)
(9)

(10) *

1 

(11) *

2

(13) *

1 

(14) *

3 

(15)

(16)

*1 Only whiteboard mode can be selected.

*2 For “Print All”, only whiteboard mode can be selected.

*3 Only overlay mode can be selected.

Set the initial color and thickness of “Pen 1” to “Pen 3”, and the initial size of the “Eraser”.

Set whether or not you can draw with your finger when the pen function is selected (page 12).

To use this function, select this to have the pen automatically switch to the eraser when the screen is touched with the eraser 
or your finger in pen mode. Set the eraser size that is applied in “Eraser Size”.

•  The area you touch (or cover) 

: When using an eraser or other object and the area of contact on the screen is at 

least 1-9/16 inch (4 cm) x 1-9/16 inch (4 cm), erase the area of contact.

•  The selected size in Eraser Palette  : Erase with the selected eraser size regardless of the amount of contact on the 

screen.

IMPORTANT

•  To use this function, select the touch panel driver “Properties”, and configure the settings on the “Operation Setting” tab 

as shown below. For information on the touch panel driver, see the Touch Panel Driver Operation Manual.
- Set “Input Mode Setting” to “Standard”. If set to other than “Standard”, the pen/eraser auto switching function cannot be 

used.

- If you have selected “The area you touch (or cover)”, set “Detect Eraser Area” to “Enable”.

Select this to have the palettes of “Pen 1” to “Pen 3” and “Eraser” close when a pattern is selected from a palette.
If the checkmark is removed,   must be clicked to close the palette.