PN-70TA3 (serv.man9). (Setup Manual) - Sharp Monitor User Guide / Operation Manual. Page 6

4

E

•  This product is for use indoors.
•  A mounting bracket compliant with VESA specifications is 

required. 

•  Since the monitor is heavy, consult your dealer before 

installing, removing or moving the monitor.

•  Mounting the monitor on the wall requires special expertise 

and the work must be performed by an authorized SHARP 
dealer. You should never attempt to perform any of this 
work yourself. Our company will bear no responsibility 
for accidents or injuries caused by improper mounting or 
mishandling.

•  Use the monitor with the surface perpendicular to a level 

surface. If necessary, the monitor may be tilted up to 20 
degrees upward. 

•  When moving the monitor, be sure to hold it with the 

handles and the unit bottom. Do not grasp the screen or 
tray. This may cause product damage, failure, or injury.

•  This monitor should be used at an ambient temperature 

between 41°F (5°C) and 95°F (35°C). Provide enough 
space around the monitor to prevent heat from 
accumulating inside.

7-7/8 [20]

Unit: inch [cm]

2 [5]

2

[5]

2

[5]

1-7/16 [3.5]

•  If it is difficult to provide sufficient space for any reason 

such as the installation of the monitor inside a housing, or 
if the ambient temperature may be outside of the range 
of 41°F (5°C) to 95°F (35°C), install a fan or take other 
measures to keep the ambient temperature within the 
required range.

•  Temperature condition may change when using the monitor 

together with the optional equipments recommended by 
SHARP. In such cases, please check the temperature 
condition specified by the optional equipments.

•  Do not block any ventilation openings. If the temperature 

inside the monitor rises, this could lead to a malfunction.

•  Do not place the monitor on a device which generates heat.
•  Do not use the product in locations where the unit is 

exposed to direct sunlight or other strong light. Since this 
product operates with infrared rays, such light may cause a 
malfunction.

•  When using multiple monitors closely, be sure the infrared 

transmitter/receiver does not affect the other ones.

Model

PN-70TA3

PN-60TA3

Power requirement

AC 100 V - 240 V, 3.0 A, 50/60 Hz

AC 100 V - 240 V, 2.5 A, 50/60 Hz

Operating temperature *

41°F to 95°F (5°C to 35°C)

Operating humidity

20% to 80% (no condensation)

Power consumption (Maximum)

250 W

210 W

Dimensions (excluding protrusions)  inch (mm)

Approx. 64-13/16 (W) x 3-11/16 (D) x 

39-3/4 (H) (1647 x 94 x 1010)

Approx. 56-9/16 (W) x 3-11/16 (D) x 

35-1/16 (H) (1437 x 94 x 890)

Weight  

lbs. (kg)

Approx. 134.5 (61)

Approx. 105.9 (48)

*  Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP.  

In such cases, please check the temperature condition specified by the optional equipments.

As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement 

without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from 

these values in individual units.