Read Sharp PN-525E (serv.man3) Service Manual online
PN-525E
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTION
2 – 4
• This monitor is designed to be installed on a concrete wall/ceiling or
pillar. Reinforced work might be necessary for some materials such
as plaster/thin plastic board/wood before starting installation.
This monitor and bracket must be installed on a wall which can
endure at least 4 times or more the weight of the monitor. Install by
endure at least 4 times or more the weight of the monitor. Install by
the most suitable method for the material and the structure.
• Use the supplied logo sticker when you install the monitor in verti-
cal orientation.
*Do not remove the factory-affixed sticker but affix the logo sticker
over it.
Be careful not to cover the remote control sensor or buttons.
■
BINDING CABLES
[Attaching the cable clamp]
The cables connected to the terminals on the back of the monitor can
be neatly bundled using the supplied cable clamps as shown in the
be neatly bundled using the supplied cable clamps as shown in the
illustration.
Caution:
• Verify the position for attaching a cable clamp in advance.
• A cable clamp cannot be removed once it is attached.
[Fastening the power cord]
1) Attach the supplied power cord clamp to the power cord, making
sure the power cord clamp is circular hole-sidedown.
2) Insert the tip of the band into the hole for the power cord clamp.
3) While holding the tail of the band, slide the fastened part toward the
AC input terminal.
INPUT
*
Hole for
the power
the power
cord clamp
Fastened
part
part
Band
Power cord
clamp
clamp
Cable clamp
Insert the cable
clamp into a hole.
(any hole available)
clamp into a hole.
(any hole available)
Cable clamp
attachment
Cable clamp
positions
1
2
3
Click on the first or last page to see other PN-525E (serv.man3) service manuals if exist.