Read Sharp LL-T1820 (serv.man9) Service Manual online
PC-UM10M
LL-T1820-H/B CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 1
CHAPTER 2. CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
1. CONNECTING THE MONITOR AND TURNING THE MONITOR ON AND OFF
Caution: • When connecting, ensure that both the monitor and com-
puter are switched off.
• Be careful not to overly bend the cable or add extension
cords as this could lead to malfunction.
Cable storage
If necessary, excess cable can be housed in the stand.
1.
Remove the cover.
Gently pull the top of the cover towards yourself.
Gently pull the top of the cover towards yourself.
2.
Run cable along the back of the stand.
Pass cable in front of the stand, and then bring it through the back.
• If the display is to be rotated, first house the cables with the dis-
play in the long height position, so there is sufficient length when
the display is turned.
3.
Refit the cover.
Be careful not to pinch the cable.
• If the cover is hard to refit, do not force it. Check whether cables
are trapped.
Caution: If the display is to be rotated, first house the cable, and then
check while gently turning the display. If it cannot be turned,
rehouse the cable with sufficient slack. (If there is insufficient
cable length, rotation will be impossible. Forcing rotation may
cable length, rotation will be impossible. Forcing rotation may
cause cable disconnection.)
CONNECTING THE MONITOR TO A COMPUTER
Connecting the monitor to a computer using the accessory signal cable.
• This monitor has two input terminals to enable connection to two
computers. The monitor comes with one analog signal and one digital
signal cable. If both connections are analog, or both are digital, you
will need another signal cable sold separately.
will need another signal cable sold separately.
• Digital signal cable: model name NL-C01E
• Analog signal cable: model name NL-C02E
Analog RGB connection
Using the accessory analog signal cable, connect to the analog RGB
output terminal of the computer.
• Paying attention to connector direction, firmly insert the signal
cable to terminal, and then tighten the screws at both sides.
If connecting to a D-sub 15 pin 2 row Apple Power Macintosh, attach a
Macintosh conversion adapter (to be purchased separately) to the ana-
log signal cable.
Input terminal 1 and 2
You can connect to
either side.
You can connect to
either side.
Analog RGB output
terminal
terminal
Analog signal cable
Macintosh conversion adapter
Click on the first or last page to see other LL-T1820 (serv.man9) service manuals if exist.