Read Sharp LL-T1811W (serv.man2) Service Manual online
LL-T1811W
2 – 3
TURNING THE POWER ON
1. Press the monitor's power button.
2. Turn on the computer.
The power LED will be lit green, and the screen will display an
image.
CHANGING BETWEEN INPUT TERMINALS
(INPUT 1
(INPUT 1
0
0
0
0
2)
Use the INPUT button to switch between signal input terminals.
Notes: (when using an analog signal)
• If using the monitor for the first time or after having changed
the system settings during use, perform an automatic screen
adjustment.
adjustment.
• When connecting to a notebook, if the notebook computer's
screen is set so that it is displaying at the same time, the
MS-DOS screen may not be able to display properly. In this
case, change the settings so that only the monitor is display-
ing.
MS-DOS screen may not be able to display properly. In this
case, change the settings so that only the monitor is display-
ing.
TURNING THE POWER OFF
1. Turn the computer off.
2. Press the monitor's power button.
The Power LED will disappear.
If the monitor is not going to be used for a long period of time, be
sure to unplug it from the AC outlet.
sure to unplug it from the AC outlet.
2. INSTRUCTIONS FOR ATTACHING A
VESA COMPLIANT ARM
An arm or stand based on the VESA standard (purchased separately)
can be attached to the monitor.
Procurement of the arm or stand is at the customer's discretion.
Arms or stands able to be used
*
Attachments must satisfy the following.
*
Compatible with the VESA standard
*
Have a gap of at least 100 mm
u
100 mm between the screw holes
on the section to be attached
*
Not be likely to fall off or break off after being attached to the moni-
tor.
tor.
How to attach the arm or stand
Notes: • Do not bend the signal cable or the AC adapter cable nor
place weight on them. Doing so could lead to damage.
• While following these instructions, please also refer to the
installation instructions in the operation manual included with
the arm or stand.
1. Spread out a soft cloth on a suitable horizontal surface.
2. Being careful not to damage the monitor, gently lay the monitor on
it display-side down.
3. Remove the stand cover and the covers to the left and to the right.
4. Remove the two screws, and remove the cover.
5.
Remove the four screws and then remove the stand from the monitor.
ON
Turn monitor on
Turn on device to
which monitor is
connected
which monitor is
connected
Press power button
INPUT-1
INPUT-2 (DIGITAL)
INPUT-2 (ANALOG)
INPUT
DVI-I input terminal
(digital)
DVI-I input terminal
(analog)
Analog signal input terminal
OFF
Turn off device to
which monitor is
connected
which monitor is
connected
Turn monitor off
Press power button
(Rear view)
Cover
Cover
Stand cover
Lift one side
Cover
Two screws
Four screws
Stand
Click on the first or last page to see other LL-T1811W (serv.man2) service manuals if exist.