Read Sharp LL-T1803 (serv.man8) Service Manual online
LL-T1803-E/P
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 1
CHAPTER 2. CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
1. CONNECTING THE MONITOR AND TURN-
ING THE MONITOR ON AND OFF
Caution: • When connecting, ensure that both the monitor and com-
puter are switched off.
• Be careful not to overly bend the cable or add extension
cords as this could lead to a malfunction.
1-1. CONNECTING THE MONITOR TO A COMPUTER
■
■
■
■
ANALOG RGB CONNECTION
Connect this deviceÅfs analog signal cable to the computer.
• Paying attention to connector direction, firmly insert the signal cable
to terminal, and then tighten the screws at both sides.
If connecting to a D-sub 15 pin 2 row Apple Power Macintosh, attach a
Macintosh conversion adapter (to be purchased separately) to the ana-
log signal cable.
■
■
■
■
DIGITAL RGB CONNECTION
Connecting the monitor to a computer via a Digital signal cable. (to be
purchased separately)
• For digital RGB connection, the monitor has an input for connecting
to a computer with a DVI-compatible output connector (DVI-D 24 pin
or DVI-I 29 pin) and SXGA output capability. (Depending on the type
of computer to be connected, the display may not work correctly.)
• Paying attention to connector direction, firmly insert the signal cable
to terminal, and then tighten the screws at both sides.
■
■
■
■
CONNECTING THE MONITOR TO A POWER SOURCE
1. Connect the AC adapter to the monitor's power terminal
2. Attach the power cord to the AC adapter and place the power plug
into the AC outlet.
1-2. CONNECTING THE MONITOR AND TURNING
THE MONITOR ON AND OFF
Caution: After unplugging the AC adaptor or power cord, be sure to wait
at least 10 seconds before plugging in again. If you put the
plug back in immediately after unplugging, damage may be
caused and the screen malfunction or not display.
■
■
■
■
TURNING THE POWER ON
1. Press the monitor's POWER button.
2. Turn on the computer.
The power LED will be lit green, and the screen will display an
image.
Notes: (when using an analog signal)
• If using the monitor for the first time or after having changed the
system settings during use, perform an automatic screen adjust-
ment.
• When connecting to a notebook, if the notebook computer's screen
is set so that it is displaying at the same time, the MS-DOS screen
may not be able to display properly. In this case, change the set-
tings so that only the monitor is displaying.
Analog RGB terminal
(Mini D-Sub 15 pin, 3 row)
(Mini D-Sub 15 pin, 3 row)
Analog signal cable
Macintosh conversion adapter
DVI-D input terminal
(DVI-D24 pin)
(DVI-D24 pin)
Digital signal cable
Digital RGB output
terminal (DVI-D 24 pin
or DVI-I 29 pin)
terminal (DVI-D 24 pin
or DVI-I 29 pin)
Power terminal
AC adapter
AC outlet
Power cord
ON
Press power button
Turn on the
computer
Click on the first or last page to see other LL-T1803 (serv.man8) service manuals if exist.