LL-T17D3 (serv.man13) - Sharp Monitor User Guide / Operation Manual. Page 13

1.Press the monitor's POWER button.
2.Turn on the computer.

The power LED will be lit green, and the screen
will display an image.

ON

Notes:
- When using an analog signal, perform an

automatic screen adjustment under the following
conditions:
- Using the monitor for the first time.
- After having changed the system settings

during use.

- Depending on the computer or OS, it may be

necessary to use the computer to install monitor
set-up information. If so, follow the steps below to
install the monitor set-up information.

- When connecting to a notebook, if the notebook

computer's screen is set so that it is displaying at
the same time, the MS-DOS screen may not be
able to display properly. In this case, change the
settings so that only the monitor is displaying.

Turn on the
computer

Press power button

Use the INPUT button to switch between signal
input terminals.

Analog RGB input

DVI-I input

terminal

terminal

INPUT-1

<ANALOG>

INPUT-2

<          >

INPUT

The input signal type (ANALOG/DIGITAL) is
displayed within angle brackets <  >.

Note:
- When there is no input signal, [NO SIGNAL] is

displayed.

1. Turn the computer off.
2. Press the monitor's POWER button.

The Power LED will disappear.

OFF

If the monitor is not going to be used for a long
period of time, be sure to unplug it from the AC
outlet.

Turn the
computer off

Press power button

02_LL-T17D3_gb.p65

11/29/2002, 5:14 PM

13