LL-T17A4 (serv.man10) - Sharp Monitor User Guide / Operation Manual. Page 17

Adjustments can be made using OSD (On Screen
Display) Menu provided.

If you are using Windows, open the Adjustment
Pattern on the accompanying Utility Disk. (p.16)
If your system is not Windows, you can not use the
Adjustment Pattern. Therefore display an image
that makes the entire screen light and adjust it
through checking visually its actual tone.
This chapter provides the procedure how to adjust
the screen by using Adjustment Pattern (for
Windows).

1. Press the MENU button.

The ADJUSTMENT Menu will be displayed.
(Example: Displayed screen of the LL-T17D4)

At this point relevant menu options can be
adjusted.
Each time the MENU button is pressed the next
menu is selected. (ADJUSTMENT 

→

 GAIN

CONTROL 

→

 WHITE BALANCE

→

 MODE

SELECT 

→

 OSD Menu disappears)

- The OSD Menu automatically disappears

approximately 30 seconds after the last
command.

- The OSD Menu screen shown as an example is

from the LL-T17D4.

Screen frame

MANUAL: Individual menu options are manually

adjusted.

AUTO:

Every menu option is automatically
adjusted.

- Press the   button to select [AUTO].
- To choose a menu option: 

 / MODE button

- To go to the next menu: MENU button

The figure below demonstrates how to adjust so
that vertical flicker noise is not emitted.

(    buttons)

The figure below demonstrates how to adjust so
that horizontal flicker noise is not emitted.

(    buttons)

- Adjustments to [PHASE] should be made only

after [CLOCK] has been correctly set.

To center the Adjustment Pattern within the
boundaries of the screen, adjust the left-right (H-
POS) values and the up-down (V-POS) values.

(    buttons)

Vertical flicker noise

Horizontal flicker noise

Adjustment

Pattern