LL-T1610W (serv.man11). LLT1610W Complete - Sharp Monitor Service Manual (repair manual). Page 10

Notes:

•

A floppy disk drive is necessary. In addition, it is neces-
sary to have PC Exchange or File Exchange installed in
your system.

•

Depending on the type of computer or OS, command
names and methods may differ. Please follow the com-
puter’s own operation manual while reading this.

1. Place the Utility Disk (provided) into the computer’s floppy disk drive.

2. Copy the profile to be used from the Mac folder on the Utility Disk

to the ColorSync profile folder located within the system folder.

3. Using the ColorSync on the control panel, choose the profile to be used.

1. Turn the computer off.

2. Press the monitor’s power button.

The Power LED will disappear.

If the monitor is not going to be used for a long period of time, be
sure to unplug it from the AC outlet.

This monitor is manufactured to work with a bus-powered hub that is
compatible with the USB standard (based on Rev.1.1).

A USB device for currents of up to 100mA can be connected.
(Devices that exceed 100mA and USB hubs with bus-powered
specifications cannot be connected.)

A USB compatible computers or USB hub with self-powered
specifications is connected here. (USB hubs with bus-powered
specifications cannot be connected.)

Notes:

•

Before connecting, ensure that the shape of the USB ca-
ble connector is correct.

•

For information regarding the USB function (such as set-
up) please refer to the operation manual of the computer
to be connected.

•

Some computers, OS and other devices may not be able
to be activated. To ascertain a certain device’s USB com-
patibility, please contact the manufacturer of the device.

1. Remove the rear cover and the stand cover.

To remove them follow steps 1 and 2 of Connecting the monitor
to a power source.

2. Plug the USB cable (provided) into the monitor’s USB upstream port.

3. Connect the second USB cable (provided) to the computer or the

USB downstream port.

4. Plug the USB device into the monitor’s USB downstream port.

5. Replace stand cover.

6. Replace rear cover.

To replace it follow step 8 of Connecting the monitor to a power
source.

■

The method of adjustment differs depending on whether the analog
signal or the digital signal is being used.

1. First perform an automatic adjustment.

2. Perform manual adjustment where necessary. 

The monitor can generally be used without adjustment. If necessary
perform manual adjustment.

Note: The OSD contents are saved even after the power is turned off.

However, if the power is turned off while the OSD menu is
displayed, the contents are not saved.

■

All adjustment values can be returned to their original ex-factory val-
ues in one command.

1. Press the power button to turn off the monitor power.

2. Press the MENU button and the SELECT button simultaneously, and

while doing this press the power button (i.e. turn the monitor on).
Continue to press the button until [ALL RESET] appears on the
screen. When [ALL RESET END] appears the reset is complete.

USB upstream port

USB cable (provided)

To the computer or another 
USB hub's downstream port

Run through hole

Run through hole

USB device

USB downstream port

1

2

Run signal cable 
and USB cable 
through here