Read Sharp LL-T15G4 Service Manual online
LL-T15G4-H/LL-T15G4-B
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 3
2. INSTRUCTIONS FOR ATTACHING A VESA-COMPLIANT ARM
An arm or stand based on the VESA standard (commercially available)
can be attached to the monitor.
Procurement of the arm or stand is at the customer's discretion.
Procurement of the arm or stand is at the customer's discretion.
• When choosing the arm to be installed please take note of the following points.
• The arm should be compatible with the VESA standard, and there
must be a gap of 75 mm x 75 mm between the screw holes on the
section to be attached.
• The arm must not fall off or break off after being attached to the monitor.
• Do not over bend the cable or add extension cords as this could lead
to malfunction.
1.
Turn off the monitor's and computer's power and remove the AC
plug from the AC outlet.
plug from the AC outlet.
2.
Remove the cables.
3.
Spread out a soft cloth on a suitable horizontal surface.
4.
Being careful not to damage the monitor, gently lay the monitor on it
display-side down.
5.
Remove the four screws and then remove the stand from the monitor.
Note:
• The stand is specially made for use with this monitor. Once having
removed the stand, never attempt to attach it to another device.
• Once having removed the screws, store them together with the stand
and if the stand is ever re-attached be sure to use the original screws.
Using different screws could lead to a malfunction.
Using different screws could lead to a malfunction.
6. Attach the arm to the monitor with four screws.
Note: The screws used to attach the arm should be M4 screws with a length
of 8 - 10 mm protruding from the surface to be attached. Using different
screws could cause the monitor to fall off or to be internally damaged.
7. Connect the cables and the power cord.
8~10mm
Screw used to attach arm
Arm
Part of monitor to which arm is attached
Click on the first or last page to see other LL-T15G4 service manuals if exist.