Read Sharp LL-T15G3 (serv.man4) Service Manual online
LL-T15G3
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 2
1-5. INSTRUCTIONS FOR ATTACHING A VESA COMPLIANT ARM
An arm or stand based on the VESA standard (commercially available)
can be attached to the monitor.
Procurement of the arm or stand is at the custom-er's discretion.
When choosing the arm to be installed please take note of the following
points.
• The arm should be compatible with the VESA standard, and there
must be a gap of 75mm x 75mm between the screw holes on the
section to be attached.
• The arm must not fall off or break off after being attached to the
monitor.
1.
Ensure that both the monitor and computer are switched off.
2.
Unplug the power cord from the AC outlet.
3.
Remove the analog signal cable from the computer.
4.
Press down on the stand and gently fold back the monitor.
• Do not overly bend the cable or add extension cords as this could
lead to malfunction.
5. Being careful not to damage the monitor, spread out a soft cloth and
lay the monitor on it display-side down.
6.
Attach the arm to the monitor with four screws.
Note: The screws used to attach the arm should be M4 screws with a
length of 8 mm ~ 10 mm protruding from the surface to be
attached. Using different screws could lead to malfunction or
attached. Using different screws could lead to malfunction or
may lead to the monitor falling off, internal damaged,personal
injury.
7. Connect the analog signal cable and power cord.
The stand may be removed.
1. Turn off the monitor, and remove the analog signal cable and the
power cord from the monitor.
2. Being careful not to damage the monitor, spread out a soft cloth and
lay the monitor on it display-side down.
3. Remove the four screws and then remove the stand from the moni-
tor.
• The stand is specially made for use with this monitor. Once hav-
ing removed the stand, never attempt to attach it to another
device.
device.
• Once having removed the screws, store them together with the
stand and if the stand is ever re-attached be sure to use the origi-
nal screws.
Using different screws could lead to a malfunction.
Using different screws could lead to a malfunction.
4. Follow instruction no.6 to attach the arm to the monitor, then con-
nect the analog signal cable and the power cord.
8~10mm
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
Part of monitor to which arm is
attached
Click on the first or last page to see other LL-T15G3 (serv.man4) service manuals if exist.