LL-T1512 (serv.man8) - Sharp Monitor User Guide / Operation Manual. Page 31

An arm or stand based on the VESA standard
(purchased separately) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.

Arms or stands able to be used
Attachments must satisfy the following.
-

Compatible with the VESA standard

Have a gap of 75 mm x 75 mm between the
screw holes on the section to be attached

Not be likely to fall off or break off after being
attached to the monitor.

Do not bend the signal cable or the AC adapter
cable nor place weight on them. Doing so could
lead to damage.

While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand

1. Turn off the monitor’s power and unplug AC plug

from AC outlet.

2. Unplug AC cord from AC adapter’s AC inlet.

When you are faced with an AC cord tightened
into AC adapter, please pull off it slowly and
carefully.

3. Remove the rear covers (a)(b)(c) in following the

instructions given in page 12.

4. Remove AC adapter from the stand.

1) Disconnect the plug from DC-IN connector.

2) Remove the cord from hook and the cord

holder.

CAUTION!
Be careful not to cut or jam your fingers.

3) While lifting AC adapter’s cord root side, slide

it toward the round opening, and then pull
toward you to remove AC adapter.

5. Remove the four screws and then remove the

stand from the monitor.

The stand is specially made for use with this
monitor. Once having removed the stand, never
attempt to attach it to another device.

Once having removed the screws, store them
together with the stand and if the stand is ever re-
attached be sure to use the original screws.
Using different screws could lead to a
malfunction.

Hook

Cord holder